Lots of people are confused over a choice up radiant heating system and the choice between Warmboard. This article should help to set you straight. To get other viewpoints, people may check out: low profile heatsinks.
A Warmboard system includes a structural subfloor using a radiant cell into one easy radiant heating system. Its basically a strong, broad, weather-resistant, 4' X 8' sheet of plywood, using a number of channels cut in to the very best plane and a solid sheet of high-grade aluminum, which will be permanently glued to each section. The metal is highly conductive. In fact, its about 30% more conductive than most typical metals, but it also cools down quickly.
Warmboard changes the normal architectural sub-floor. It could be cut, nailed or screwed straight to your floor joists similar to any old-fashioned sub-floor.
Most Warmboard systems function with water ranging in temperature between 90 and 110, but if you're considering a wool rug, o-r still another large resilient floor, you can still run your home heating effectively and easily raise your water conditions.
Warmboard also have two important properties - they have high conductivity and reduced thermal mass, this means they will heat us quickly and retain heat quite well, although not quite as long as glowing systems imbedded in concrete.
In contrast, a staple up radiant heat system is the most unobtrusive radiant heat to put in within an existing home. It will not include any extra floor height or affect your existing floor coverings as it is fitted underneath the current sub-floor between your floor joists.
This system is ideal when you want to include a heat system without changing your floors or floor coverings. For instance, if your basement is unfinished you may easily staple up sparkling heat tubing between your roof, or floor joists.
A staple-up process is not as responsive since the aluminum base technique, but is more responsive than the thermal mass method- because under-floor radiant heat must heat up the wood subfloor and floor above. To radiate more heat in to your house, you may want to consider installing heat transfer plates.
Heat transfer dishes will ensure that your temperature continues a lot longer. They are a much better heat conductor than wood, which means that your home would not only heat up faster, the heat would also last longer if exchange plates were used.
Overall both methods have their strengths. So far as labor goes, a Warmboard cell system would save you time and labor they are much simpler to install, but depending on where you plan to install your radiant heat system, both Warmboard and under-floor radiant heat methods are a clean and economical approach to take.
Copyright © by the contributing authors, 2007-2025.